INSTEON Dimmer Module - 2632-422 (France), 2632-432 (Germany), 2632-442 (UK), 2632-522 (AUS/NZ) Quick Start User Manual
Quick start guide, Insteon, Dimmer module
2632-422/2632-432/2632-442/2632-522 Rev. 11/26/2012 2:50 PM / See Owner’s Manual for warranty information.
Protected under U.S. and foreign patents (s
© Copyright 2012 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 866-243-8022
Quick Start Guide
INSTEON
®
Dimmer Module
Models: 2632-422, 2632-432, 2632-442, 2632-522
Install INSTEON Dimmer Module
1) Turn on lamp
2) Unplug lamp and plug it into Dimmer Module receptacle
3) Plug Dimmer Module into unswitched wall outlet
Lamp will turn on and Dimmer Module LED will turn on green
Make Dimmer Module a Responder
1) Press and hold controller button until it beeps
Controller LED will start blinking
2) Press and hold Dimmer Module paddle top or bottom to adjust load to desired
brightness (or off) when scene is activated
3) Press and hold Dimmer Module set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off
Connected load will return to the state set in step #2
Assign an X-10 Address
1)
Press and hold Dimmer Module set button until it beeps
Dimmer Module LED will start blinking green
2)
Send the X10 address 3 times (with or without commands)
Example: A1-A1-A1-AON or A1-AON-A1-AON-A1-AON
Dimmer Module will double-beep and its LED will stop blinking
3)
Test by sending X10 on and off commands
Load will turn on and off
Owner’s Manual and Tech Support
Visit:
for complete manual, online tech support and updated product documents.
Call: INSTEON Support Line at 866-243-8022
2632-442
(UK)
Paddle top
(on/brighten)
2632-422
(France)
2632-432
(Germany)
2632-522
(Aus/NZ)
LED
Set button
Paddle top
(off/dim)