Clear-Com WTR-670 - Manual (Page 58)

Certification Information
14-1
S
ection
14
FCC LICENSING
The WBS-670 and the WTR-670 Transmitter/Receiver are Type Accepted under United States Fed-
eral Communications Commission Part 74. Licensing of equipment is the User’s responsibility and
licensibility depends on the user’s classification, users application, and frequency selected. Clear-Com
strongly urges the user to contact the appropriate telecommunications authority for any desired clarifi-
cation.
CAUTION: Changes or modifications made by the user could void the user’s authority to operate
the equipment.
Mandatory Safety Instructions
to Base Station Installers and Users
1. Use only manufacturer or dealer supplied antenna.
Antenna Minimum Safe Distance: 20 cm
Antenna Gain: zero dBd referenced to a dipole.
2. The FEDERAL COMMUNICATIONS COMMISSION has adopted a safety standard for human exposure
to RF (Radio Frequency) energy, which is below the OSHA (Occupational Safety and Health Act) limits.
3. Antenna Mounting: The antenna supplied by the manufacturer or radio dealer must not be mounted at a lo-
cation such that during radio transmission, any person or persons can come closer than the above indicated
minimum safe distance to the antenna i.e. 20 cm.
4. To comply with current FCC RF Exposure limits, the antenna must be installed at or exceeding the mini-
mum safe distance shown above, and in accordance with the requirements of the antenna manufacturer or
supplier.
5. Base Station Installation: The antenna should be fixed-mounted on an outdoor permanent structure. RF
Exposure compliance must be addressed at the time of installation.
6. Antenna substitution: Do not substitute any antenna for the one supplied or recommended by the manu-
facturer or radio dealer. You may be exposing person or persons to harmful radio frequency radiation.
You may contact your radio dealer or the manufacturer for further instructions.
7. WARNING: Maintain a separation distance from the antenna to person(s) of at least 20cm.
You, as the qualified end-user of this radio device must control the exposure conditions of bystanders to
ensure that the minimum separation distance (above) is maintained between the antenna and nearby per-
sons for satisfying RF Exposure compliance.
The operation of this transmitter must satisfy the requirements of the Occupational/Controlled Exposure
Environment for work-related use. Transmit only when person(s) are at least the minimum distance from
the properly installed, externally mounted antenna.