Clear-Com WTR-670 - Manual (Page 41)

Receive Screen
The Receive screen allows the user to set the beltpack receive
frequency. This corresponds to the base station’s transmit fre-
quency. In factory-defined groups receive is not changeable.
User-programable groups will allow the user to change the fre-
quency in 25 KHz steps.
•
Press [MENU] twice from the group/channel screen to ar-
rive at the receive frequency screen.
•
(User-Programmable Groups Only) Press [SET] to edit
the frequency. The number will start flashing. Fac-
tory-defined groups can’t be changed; so pressing set will
do nothing at this screen. User-programmed groups will
start flashing and allow the user to change the frequency
in 25kHz steps.
•
(User-Programmable Groups Only) Use the
[UP]/[DOWN] arrow buttons to change the frequency.
•
(User-Programmable Groups Only) Press [SET] to place
the beltpack on the frequency selected. If set is held
down, during that time the group is displayed so the user
is aware of what group the unit has been placed. Once set
is released, the unit returns to the receive frequency
screen with nothing flashing.
•
(User-Programmable Groups Only) Pressing [SET] once
more will start the editing sequence over again. Pressing
[MENU] during receive frequency edit will end editing
and send the user back to the receive screen without any
changes.
6-16
554.250
[SET]
554.250
R1
R1
566.750
R1
[SET] IS HELD DOWN
27u
GP
[SET] IS RELEASED
END
566.750
R1
[UP] / [DOWN]
Receive Screen