Clear-Com HME DX121 User Manual

Page 24

If registration failed:

• A voice message will say “Power on, Speaker, Version #, Begin registration, …”

The ISO and IC lights on the Speaker Statio n will be blinking red, and there may be a delay of up to
90 seconds before you hear “Registration failed,” and the STATUS display (#4) goes blank.

• Press RESET (#7) on the Base Station. To press RESET, insert a small paper clip or similar object

into the RESET hole at the lower-left corner of the Base Station front panel. When the STATUS
display (#4) becomes blank, press the REG button (#6) on the Base Station and register the Speaker
Station again. If registration fails again, call your dealer for assistance.

If you try to register more than 4 COMMUNICATOR

s to a Base Station:

• An “F” (for registration “Full”) will appear on the Base Station STATUS display (#4), and you will

hear “Registration failed.”

• Clear all current registrations by pressing the CLR/BND button (#5) and RESET (#7) on the Base

Station at the same time. To press RESET, insert a small paper clip or similar object into the RESET
hole at the lower-left corner of the Base Station front panel. Continue holding the CLR/BND button
after you release RESET, until the clear code “c” (lower case) appears on the STATUS display.

• Register all active Speaker Stations, one at a time.

4 6