Clear-Com HME DX121 - Manual (Page 23)

19
o
4 6
Register Speaker Stations
The first time you operate a Speaker Station, you must register it for use with a specific Base Station. The Base
Station will then recognize the Speaker Station when its power is on, and will be able to tell the difference between
it and other electronic equipment operating on similar frequencies, or DX family Beltpacs or All-in-one Headsets.
NOTE: The Speaker Station must be within 6 feet (1.83 meters) of the Base Station while being registered.
Registration Procedure:
• Be sure the Speaker Station is turned off and the Base Station power is on.
• On the Base Station, press and release the REG button (#6).
⎯ The STATUS display (#4) will show a small “o” for open.
• On the Speaker Station, press and hold the ISO button while you press and release the POWER button to turn
the unit on, and then release the ISO button. This will cause the Speaker Station to enter the registration mode.
⎯ The STATUS display on the Base Station will continue to show a small “o.”
⎯ The ISO and IC lights on the Speaker Station will be blinking red then will change to a steady green
IC light.
If registration is successfully completed:
• If you have a headset plugged into the Speaker Station or if the speaker is on, you will hear a voice
message in the headset or speaker saying “Power on, Speaker #, Version #, Begin registration,
Registration complete…”
• After a delay of up to 15 seconds, the STATUS display on the Base Station will show the ID number
assigned to the Speaker Station, for about 10 seconds.
NOTE: ID numbers are assigned sequentially to registered COMMUNICATOR ®
s as 0 thru 3.
• The IC light on the Speaker Station will remain on steady green.
IC button
and light
ISO button
and light