Clear-Com HME DX121 User Manual

Page 18

If registration is successfully completed:

• A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, Registration

complete, …”

• After a delay of up to 15 seconds, the STATUS display will show the ID number assigned to this Beltpac for

about 10 seconds.
NOTE: ID numbers are assigned sequentially as 0 thru 3.

• The power light on the Beltpac, next to the IC button, will remain on steady green.

•

Repeat Steps 1 to 3 at the bottom of page 13 for each Beltpac to be registered.

If registration failed:

• A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, …” Both

power lights on the Beltpac will be blinking red, and there may be a delay of up to 90 seconds before you
hear “Registration failed” and the STATUS display (#4) goes blank.

• Press RESET (#7) on the Base Station. To press RESET, insert a small paper clip or similar object into

the RESET hole at the lower-left corner of the Base Station front panel. When the STATUS display (#4)
becomes blank, press the REG button (#6) and register the Beltpac again. If registration fails again, call
your dealer for assistance.

If you try to register more than 4 COMMUNICATOR

s to a Base Station

• An “F” (for registration “Full”) will appear on the STATUS display (#4) on the Base Station and you will

hear “Registration failed” in the Headset.

• Clear all current registrations by pressing the CLR/BND button (#5) and RESET (#7) at the same time. To

press RESET, insert a small paper clip or similar object into the RESET hole at the lower-left corner of the
Base Station front panel. Continue holding the CLR/BND button after you release RESET, until the clear
code “c” (lower case) appears on the STATUS display.

• Register all active Beltpacs, one at a time.

4 6