Clear-Com HME DX121 User Manual

Page 20

If the registration is successfully completed:

• A voice message in the Headset will say “Power on, Headset #, Version #, Begin registration, Registration

complete, …”

• After a delay of up to 15 seconds, the STATUS display will show the ID number assigned to this Headset for

about 10 seconds.
NOTE: ID numbers are assigned sequentially as 0 thru 3.

• The power light on the Headset will remain on steady green.
• Repeat Steps 1 to 3 at the bottom of page 15 for each Headset to be registered.

If registration failed:

• A voice message in the Headset will say “Power on, Headset #, Version #, Begin registration, …” The

power light on the Headset will be blinking red, and there may be a delay of up to 90 seconds before you
hear “Registration failed” and the STATUS display (#4) goes blank.

• Press RESET (#7) on the Base Station. To press RESET, insert a small paper clip or similar object into

the RESET hole at the lower-left corner of the Base Station front panel. When the STATUS display (#4)
becomes blank, press the REG button (#6) and register the Headset again. If registration fails again, call
your dealer for assistance.

If you try to register more than 4 COMMUNICATOR

s to a Base Station

• An “F” (for registration “Full”) will appear on the STATUS display (#4) on the Base Station and you will

hear “Registration failed” in the Headset.

• Clear all current registrations by pressing the CLR/BND button (#5) and RESET (#7) at the same time.

To press RESET, insert a small paper clip or similar object into the RESET hole at the lower-left corner
of the Base Station front panel. Continue holding the CLR/BND button after you release RESET, until the
clear code “c” (lower case) appears on the STATUS display.

• Register all active WH200 Headsets, one at a time.

4 6