Clear-Com HX System Frames - Manual (Page 70)

Figure 28: GPI-6 interface module examples
Figure 28 shows you how to connect switches or contacts using the power source provided
by the GPI-6 module or powering switches from external sources. Each input can be wired to
be isolated from each other as a further variation.
Wiring the GPI-6 to an IMF-102 interface frame
The wiring of a GPI-6 interface that is placed in an IMF-102 interface frame is the same as
the wiring for a GPI-6 interface placed in an IMF-3 interface frame.
The only difference is that an IMF-102 interface frame houses only two interfaces, and they
are mounted horizontally rather than vertically in the frame.
Tip: Figure 5: IMF-3 rear panel and Figure 4: IMF-102 rear panel illustrate the differences
between these interface frames.
For more information, see your IMF-102 and IMF-3 documentation.
To define an input function, use the EHX configuration software (see your EHX
documentation and EHX Help).
70 Eclipse HX Matrix Frame Installation Guide