Clear-Com HX System Frames - Manual (Page 61)

Key to Figure 19: Wiring an IMF-3 rear panel to a TEL-14 interface module
Connector Instruction / description
A
The upper DB-9M connector is used to connect to the first telephone
line, line A.
B
The upper RJ-45 connector is then used to connect telephone line A to
the matrix frame.
C
The lower DB-9M connector is used to connect to the second telephone
line, line B.
D
The lower RJ-45 connector is used to connect telephone line B to the
matrix frame.
Table 16: Key to Figure 20; Wiring an IMF-3 rear panel to a TEL-14 interface module
Note:
To allow use of a common RJ-11 terminated telephone line, Clear-Com provides two DB-9F
to RJ-11 adapters (Clear-Com part 770025).
For internal dip-switch settings and adjustments, see the TEL-14 manual.
Wiring a TEL-14 interface to an IMF-102 interface frame
On the rear of the IMF-102, there are two sets of four connectors each, arranged
horizontally.
Figure 23: Wiring an IMF-102 rear panel assembly to a TEL-14 interface
Ch. A
Matrix
Ch. A
I / O
Ch. B
Matrix
Ch. B
I / O
Ch. A
Matrix
Ch. A
I / O
Ch. B
Matrix
Ch. B
I / O
A B C D
61 Eclipse HX Matrix Frame Installation Guide