Fluid Components International CMF Series Manual Installation of Electronics - Manual (Page 2)

In
st
allation of signal con.
FlexCOR
™
Model CMF Series 32
Fluid Components Intl
Document 06EN003327 Rev. -
1
2
4
3
5
1. Remove the outer frame using a finger-
nail or a screwdriver.
2. Loosen the 4 screws retaining the control
pad.
3. Withdraw the control pad and turn it to the
required orientation.
4. Tighten the 4 screws until a mechanical
stop is felt in order to obtain IP 67 enclo-
sure rating.
5. Snap-lock the outer frame onto the control
pad (click).
The transmitter can be mounted in either direction as the arrow indicates by turning the PCB but
without turning the terminal box.
Turning the control pad
Turning the transmitter
The terminal box can be rotated ±90° in order to optimize the viewing angle of the tramsmitter
display/keypad:
Unscrew the four screws in the bottom of the terminal box. Turn the terminal box to the required
position and re-tighten the screws firmly.