Fluid Components International CMF Series Manual Installation of Electronics - Manual (Page 11)

In
st
allation of signal con.
Fluid Components Intl
Document 06EN003327 Rev. - 41 FlexCOR
™
Model CMF Series
5.2.10 Remote installation
of multiple plug at
the sensor
For remote installation mount the adaptor on
top of the sensor interface. If not already
mounted.
When fitting the multiple plug, please make
sure that it is correctly oriented (note the little
tap).
The adaptor can be oriented in 4 directions.
Tighten the 4 screws with a 4 mm allen key
to secure the adaptor.
Mount the multiple plug in the adaptor and
tighten the glands on the plug to obtain opti-
mum sealing.
Note the wire colors when connecting the
instrument. Refer to the diagram for electrical
wiring, see “Electrical connection”.
After placing, it can be turned 0 - 360°.