Burkert Type 1066 - Manual (Page 7)

1066 - 5
G
ENERAL
I
NFORMATION
english
Guarantee conditions
Scope of Delivery
Immediately after receiving the shipment, ensure that the contents are undamaged and correspond to the
scope of the delivery listed on the enclosed packing note. In case of any discrepancies, please contact
our Call Center:
Bürkert Fluid Control System, Call Center
Chr.-Bürkert-Str. 13-17, D-74653 Ingelfingen
Tel. 07940 - 10 111 / Fax 07940 - 10
91 448
E-Mail: [email protected]
or your local Bürkert Sales Center immediately.
This document contains no agreement to provide a guarantee. We would refer you here to our General
Selling and Business Conditions. The precondition for the guarantee is the correct usage of the device
under compliance with the specified application conditions.
The guarantee only applies to the freedom from fault of the Head Control of the
process valves. No liability will be accepted, however, for consequential damage of any
kind that could arise from the failure or malfunctioning of the device.
ATTENTION!
• Avoid larger mechanical loads on the control head, as these may lead to mechanical impairment or
destruction of the control head. These include walking on the control head, placing heavy objects on it,
heavy impacts, falling hard objects etc.
• Avoid the infiltration of moisture into the control head. When assembling in particular, make sure that all
seals are fitted according to directions and assembly screws, cable screw connections and sealing
plugs are securely tightened. Use only dried control air!
NOTE The control head is designed in protection type IP67. This supposes that all seals
are positioned correctly and that casing and cover are mechanically intact.
NOTE With regard to its mechanical resistance, the plastic casing of the control
head is designed for direct attachment of flexible hoses and conduits only.
NOTE Cleaning products often contain aggressive components that may become
deposited in small grooves and cavities on the control head, and their prolonged
effect may lead to the desctruction even of high-quality plastics.
NOTE A pressure-relief valve is situated on the underside of the control head casing,
serving as rupture protection in the event of an leaky component in the control
head (leakage incident).
• Avoid attaching longer and mechanically rigid attachment parts, since extensions of this type would
produce leverages through which the casing could be destroyed by hand.
• Use only highly compatible cleaning products when cleaning the control head and rinse thoroughly with
clear water after these cleaning products have been used. The compatibility of the cleaning product
should be tested where necessary.
• When assembling the control head, ensure a minimum distance of 5 mm between the pressure-relief
valve and the neighbouring component so that the pressure-relief valve can disengange without
problems in the event leaking. Otherwise, the cover could literally be "exploded" in the event of leakage
in the control head.
• If these instructions are ignored, no liability will be accepted from our side, and the guarantee on the
device and its accessories will also become invalid!