Burkert Type 1066 - Manual (Page 16)

14 - 1066
I
NSTALLATION
english
Fit the electrical connections
Control heads without and
with communication
(see chapter on electrical installation)
Adjust
the proximity sensors
Using a screwdriver, turn the adjusting
screw (spindle) until the optimal position
of the proximity switch has been set up.
The LED mounted on the proximity switch
is an adjustment aid: it lights up when
reaching the corresponding threshold value.
the limit position micro-switches
When using micro-switches, LEDs are not
provided for reasons of cost
Set the position as for the proximity
switches
Using the switching sound
of the micro-switch
(very quiet) as a setting
aid or external electrical
continuity check.
LED
LED
NOTE
Secure the cover where necessary to prevent
unauthorised access by inserting a lead seal
and/or self-tapping screw in the holes in the
cover and the housing.
5
6
Housing
with cover
collar and
O-ring seat
Fit the cover
Check the seat of the cover O-ring,
or pull a new O-ring onto the collar of
the cover.
7
NOTE
Distributed across the circumference of
the casing are 4 handles that retain the
O ring when the cover is being
removed. Take care to ensure that the
newly-applied O ring is positioned
correctly under the handles and is
resting on the casing without twisting.
Fit the cover.
Turn the cover right until it reaches the
stop.