Burkert Type 1066 - Manual (Page 15)

1066 - 13
I
NSTALLATION
english
Installation procedure
Fix the flange adapter to the
process valve/Fix switching knob
to piston rod (customer-specific)
ensure that it is centred
Remove the cover from the control
head
Loosen the locking screw
Turn the cover to the left to the stop
Pull the cover off upwards
Insert the control head onto
the flange adapter
Position the control head
(control head can be turned through 360°)
Secure the control head using the two
screws on the side
Fit the pneumatic connections
Refer to Pneumatic Installation,
(Installation/Commissioning chapter)
1 2
3 4