Burkert Type 6212 - Manual (Page 3)

8
note!
Electrostatic sensitive components / modules!
The device contains electronic components which react
sensitively to electrostatic discharge (ESD). Contact with
electrostatically charged persons or objects is hazardous
to these components. In the worst case scenario, they
will be destroyed immediately or will fail after start-up.
Observe the requirements in accordance with EN •
61340-5-1 and 5-2 to minimise or avoid the possibility of
damage caused by sudden electrostatic discharge!
Also ensure that you do not touch the electronic compo-
•
nents when the power supply voltage is present!
Type 6212 was developed with due consideration
given to accepted safety rules and is state-of-
the-art. Nevertheless, dangerous situations may
occur.
Failure to observe this operating manual and its oper-
ating instructions as well as unauthorized tampering with
the device release us from any liability and also invalidate
the warranty covering the devices and accessories!
english 9
general infOrmaTiOn 5.
scope of supply 5.1.
Check immediately upon receipt of the delivery that the con-
tents are not damaged and that the type and scope agree
with the delivery note and packing list.
If there are any discrepancies, please contact us immediately.
contact addresses 5.2.
germany
Bürkert Fluid Control Systems
Sales Center
Chr.-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]
international
Contact addresses can be found on the final pages of the
printed operating instructions.
And also on the Internet at:
www.burkert.com Bürkert Company Locations
english
10
Warranty 5.3.
This document contains no promise of guarantee. Please refer
to our general terms of sales and delivery. The warranty is only
valid if the Type 6212 is used as intended in accordance with
the specified application conditions.
The warranty extends only to defects in the Type
6212 and its components.
We accept no liability for any kind of collateral
damage which could occur due to failure or mal-
function of the device.
approvals 5.4.
The approval rating on the Bürkert labels concerns to Bürkert
products.
Devices that carry the e1 marking have been approved by
the Federal Office for Motorized Transport under the type
approval number
e1*72/245*2006/96*5791*00
and will be brought into circulation with the indicated approval
designation
english 11
You can obtain an excerpt from the type approval from the
address below
Bürkert Werke GmbH & Co KG
Zulassungsbeauftragter
Christian-Bürkert-Str. 13-17
D-74653 Ingelfingen
information on the internet 5.5.
The operating instructions and data sheets for Type 6212
can be found on the Internet at:
www.burkert.com Documentation Type 6212
english
Type 6212