Burkert Type 6106 - Manual (Page 12)

12
Installation
6.5.7. Protection class
Electrical connection
Protection class
without
matching
plug
connector
with
matching
plug
connector
Appliance socket connection in
accordance with DIN 43650 form C
IP20 IP65
Circular plug connection M8, 3-pole
2 pressed-in single wires 0.2 mm
2
(AWG 24)
IP65 -
Rectangular plug connection, 2-pole
IP20 IP20 Rectangular plug connection, 2-pole
without protective collar
7. INSTALLATION
7.1. Safety instructions
DANGER!
Danger of explosion!
The device is a closed system. It must not be removed.
Risk of electric shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
• Live terminals in the terminal box may cause an electric shock,
short-circuit or explosion. Switch off the power supply. Only then
open the terminal box.
• The connection lines of the electromagnets must be permanently
installed in such a way that they are adequately protected from
mechanical damage.
• Observe applicable accident prevention and safety regulations
for electrical equipment!
WARNING!
Danger – high pressure!
When reaching into the system, there is an acute risk of injury.
• Before dismounting pneumatic lines and valves, turn off the pres-
sure and vent the lines.
• During the installation, make certain the flow direction is correct.
• Observe applicable accident prevention and safety regulations
for pressurized devices.
english
PTB 01 ATEX 2175