Burkert Type 1062 - Manual (Page 34)

34
Commissioning
Type 1062
8.2.6 Wiring a version with double
inductive 4-wire switch
500 mA
150 mA max.
+ -
+
- 10-30 VDC
150 mA max.
+ -
0V
S02
S01
V+ 1
2
3
4
S01
S02
Load 1
Load 2
Power supply
Reaction speed
according to the
max. load
Orange light (valve open detection)
Green light
(voltage
present)
Red light (valve closed detection)
Fig. 17: Wiring the 2 outputs of a version with a double inductive
4-wire switch, in PNP mode, valve open detection (output
S01) and/or valve closed detection (output S02)
9 commissioninG
9.1 safety instructions
Warning
Danger due to nonconforming commissioning.
Nonconforming commissioning could lead to injuries and damage
the device and its surroundings.
▶ Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
▶ In particular, observe the safety recommendations and intended
use.
▶ The device/installation must only be commissioned by suitably
trained staff.
▶ Protect the device against electromagnetic interference and
ultraviolet rays.
protect this device against electromagnetic inter-
ference, ultraviolet rays and, when installed outdoors,
the effects of climatic conditions.
9.2 setting the cams
Activate the valve to check the correct detection of the open and/or
closed position.
If detection is incorrect, reposition each cam opposite its switch
according to the position of the valve as shown in the photos in „Fig.
17“.
english