FlexLink AGS Монтаж - Manual (Page 6)

Specification
Unit/Dept. Document type Date
APD/Research & Development Assembly Instruction 2006-05-19
Issued by Document number Page Approved by
Fredrik Johansson 3928587-03 6/12 FJn
3928587_03.DOC
Archived
3. Guide unit supply
The Guide unit cable is a factory-made cable with fixed length and connectors in both
ends.
The Control box, Junction box and the Guide unit are equipped with same type of
connectors.
WARNING! Disconnect electrical power by switching off the main switch of the Control box
before any electrical installation is started. Lock the switch with a padlock until the
installation is finished.
• Start by plugging the Guide unit cable into the Control box or Junction box,
thereafter into the Guide unit.
• Proceed by connecting the rest of Guide units controlled by the same Control or
Junction box.
Guide unit
Box
1. 2. 3.
3.1 Connectors
When connecting two connectors the catch must say "click". The Guide units otherwise
risk to malfunction.
For disconnection see picture below.