ClimaCool SHC onDEMAND 30, 50, 70, 85 Manual - Manual (Page 19)

17
www.climacoolcorp.com
ƒ–‡”‡’‡”ƒ–—”‡‡“—‹”‡‡–•
ƒ–‡”
‡’‡”ƒ–—”‡
‹‹–•
‘ƒ†‘‘’• ‹‹— ͙ ƒš‹— ͙
Chilled Water 20°F 1 62°F
Hot Water 80°F 135°F
ƒ–‡”
‡’‡”ƒ–—”‡
‹‹–•
‘—” ‡‘‘’ ‹‹— ͙ ƒš‹— ͙
Heating Mode 20°F
1
62°F
Cooling Mode 80°F 135°F
Notes:
1. Operation below 40°F requires adequate glycol/antifreeze solution.
2. All modules can operate safety in this range without the need of special controls.
3. A glycol solution additive is required at lower operating suction temperatures in order to
protect the evaporator from freeze-ups.
͘Ǥ ƒš‹—ν‘ˆ͕͔͔η ‹•ƒŽŽ‘™‡†„‡–™‡‡Ž‡ƒ˜‹‰Ž‘ƒ†–‡’‡”ƒ–—”‡ƒ†Ž‡ƒ˜‹‰•‘—” ‡
temperature for all products as well as leaving load heating temperature and leaving load
cooling temperature for SHC onDEMAND heat recovery products. (Example: if using glycol
and a chilled water temp of 25°F, maximum source water temp would be 125°F).
5. LWT: Leaving Water Temperature