CEMB USA ER100 - Manual (Page 70)

70
use and maintenance manual Rev. 11-2011
ENGLISH
8.4 MACHINE CALIBRATION
Saves the calibration values
Confirm
Goes back to the setup screen
Return to main screen
Reserved Setup
Dismount any wheel from the wheel balancing machine, close the spindle and the guard and press the button 1.
Open the guard, fit the calibration tool on the outside of the adapter (as shown in the figure), close the guard and 2.
press
Open the guard, fit the calibration tool on the inside of the adapter (as shown in the figure) in the same hole used 3.
for the previous spin, close the guard and press
Move the tool to the top at 12 o’clock and press the button 4.
Press the button 5. .
R
emove The cAlIbRATIoN Tool
;
peRfoRmING A bAlANcING spIN WITh The cAlIbRATIoN Tool fITTed oN The INsIde mIGhT cAuse seRIous
dAmAGe To The INTeRNAl lAseR
.
6. Press to exit from the screen.