C.E. Niehoff & Co. C130/C131/C132 Inst/Parts Rep/TG Combo Guide - Manual (Page 7)

Page 7 SM40A
Parts Replacement Instructions
(CONT’D)
Anti-drive End (ADE) Regulator
Replacement
Install New ADE Cover on Alternator (see Figures 1
and 2):
1. Plug alternator-to-regulator harness securely into new
regulator.
2. Install new regulator on plate using new screws from
kit. Use a suitable adhesive such as Loctite® 222.
Follow manufacturer’s instructions. Torque screws to
2.8 Nm/25 lb. in.
3. Re-install ADE cover plate. Position louvers consis-
tent with deflection of rain or fluids during normal
operating conditions.
4. Fasten in four places with screws and washers. Use a
suitable adhesive such as Loctite® 222. Follow manu-
facturer’s instructions. Torque screws to 3.4 Nm/
30 lb. in.
Remove ADE Regulator on Alternator (see Figures 1
and 2):
1. Remove hardware and ADE cover plate.
2. Remove and discard hardware attaching regulator
to plate.
3. Unplug alternator-to-regulator harness from
regulator.
4. Discard regulator.
Figure 2 –Regulator Replacement
Regulator Alternator-to-regulator harness plug
A
B
C
D
E