PA Industries Edge Sequential Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 7)

ULTRA EDGE SEQUENTIAL 6 /05/2002
7
• Current mode of the feed
• Batch Count, current and total
OPERATOR screen shows Batch Count parameter and Step Status command and allows editing batch count:
C o u n t C o n t . R u n
S t e p S t a t u s <
P r e s s O P E R t o e x i t
Count is the number of cycles that should be performed. It is a numeric entry with a range of 0 to 9999999. Entering
“0” will result in a continuous run.
Step Status command opens a screen that shows which step is currently running and how many times it has been
repeated
T # l
S t e p 1 o f 2 5
R e p e a t 1 o f 3
P r e s s O P E R t o e x i t
Every time the “OPER” key is pressed it toggles between the FEED STATUS screen and the OPERATOR screen.
3.2 “TOOLS” KEY
“TOOLS” key controls appearance of TOOL STORAGE screens. Press the “TOOLS” key to open the first screen.
This allows the Operator to choose a Tool Storage operation: “Edit Tool”, “Activate Tool”, or “Create New Tool”.
Position the pointer on desired line, using “ ↑” and “↓” keys , and press the “ENTER” key.
Enter in the tool number or select it from the tool list using “ ↑” and “↓” keys and press the “ENTER” key again.
E d i t T o o l # 1
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
A c t i v a t e
T o o l # 1
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
C r e a t e T o o l #
P r e s s T O O L S t o e x i t
E d i t T o o l
A c t i v a t e T o o l <
C r e a t e N e w
P r e s s T O O L S t o e x i t