PA Industries Edge Sequential Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 18)

ULTRA EDGE SEQUENTIAL 6 /05/2002
18
4.4 HOW TO INSERT A STEP BETWEEN OTHER STEPS
Open the Tool for editing:
T # 1 S # 1 / 2 4
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
Bring up the step before or after which you need to insert a new step and press “F1” key,
T # 1 S # 1 6 / 2 4
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
position the pointer next to INSERT STEP command and press the “ENTER” key.
A d d S t e p
D e l e t e S t e p
I n s e r t S t e p <
P r e s s F 1 f o r n e x t
Position the cursor next to desired command and press Enter key:
I n s e r t S t e p
B e f o r e S t e p 1 6 <
A f t e r S t e p 1 6
P r e s s B K S P f o r p r e v .
A new step will be inserted and step numbers reassigned accordingly.
4.5 HOW TO COPY A STEP INTO ANOTHER STEP
Open the Tool for editing and press “F1” key,
T # 1 S # 1 / 2 4
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
Press F1 again,
C o p y S t e p <
F 1 - E x i t B K S P - P r e v
Specify which step is to be copied and where to, then position the cursor next to the command Perform Copy and
press Enter key.
C o p y S t e p 3
I n t o S t e p 7
P e r f o r m c o p y <
P r e s s B K S P f o r p r e v .