PA Industries Edge Sequential Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 19)

ULTRA EDGE SEQUENTIAL 6 /05/2002
19
S t e p c o p i e d !
4.6 HOW TO DELETE A STEP
Open the Tool for editing:
T # 1 S # 1 / 2 4
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
Bring up the step that is to be deleted press “F1” key,
T # 1 S # 1 6 / 2 4
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
position the pointer next to DELETE STEP command and press the “ENTER” key.
A d d S t e p
D e l e t e S t e p <
I n s e r t S t e p
P r e s s F 1 f o r n e x t
D e l e t e S t e p 1 6
P r e s s 1 t o c o n f i r m
A n o t h e r k e y t o a b o r t
S t e p 1 6 d e l e t e d !
or
A b o r t e d !
4.7 HOW TO CREATE A NEW TOOL USING AN EXISTING ONE
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and FEED STATUS screen is displayed. If the current screen is not FEED STATUS one then press
the “OPER” key to bring it up.
Press “TOOLS” key, position the pointer next to EDIT TOOL command and press the “ENTER” key.