PA Industries Edge Sequential Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 6)

ULTRA EDGE SEQUENTIAL 6 /05/2002
6
P / A I n d u s t r i e s
R e a l l y C o o l F e e d
V e r s i o n 1 . 1 0 S E Q
H i t a n y k e y t o c o n t .
NOTE: The OPERATOR terminal has five mode keys, they are:
● “OPER”
● “TOOLS”
● “SETUP”
● “F1”
● “F2”
NOTE: ▓ The flashing cursor is waiting for the value to be entered.
NOTE: < The pointer prompts to press the “ENTER” key.
NOTE: To confirm any ENTRY, press “ENTER”.
3.1 “OPER” KEY
“OPER” key controls toggles between two screens: FEED STATUS screen and OPERATOR screen.
FEED STATUS screen shows:
T # 1
M a n u a l M o d e
3 0 / C o n t . R u n
P r e s s a M o d e K e y
• Active tool number. In case there is no active tool “No Tool!” message is displayed instead