PA Industries Edge Sequential Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual - Manual (Page 23)

ULTRA EDGE SEQUENTIAL 6 /05/2002
23
Press “SETUP” key three times, position cursor next to desired parameter, enter in new value, and press the
“ENTER” key.
S p e e d 7 2 . 0 0
A c c e l 4 0 0 . 0 0
D e c e l 4 0 0 . 0 0
P r e s s S E T U P f o r n e x t
Press “OPER” key if editing is done or press “SETUP” key to open next screen.
4.11 HOW TO EDIT COUNT FROM OPERATOR SCREEN
Locate the OPERATOR screen, position cursor next to the Count, enter new value, and press the “ENTER” key.
Enter “0” for continuous run.
C o u n t C o n t . R u n
S t e p S t a t u s
P r e s s O P E R t o e x i t
5 OPERATING THE ULTRA EDGE SERVO FEED
5.1 PROGRAMMING
There is no need to program anything if the Tool Storage is properly set up. It is only matter of activating the needed
tool, although the OPERATOR screen allows the Operator to edit a batch count that overrides the stored tool Count
and will be active until the current tool is reactivated or another tool is activated.
Activate tool is the only command that is Operator accessible and can be executed only when the feed is not cycling.
5.2 “AUTO / MANUAL” MODE
Auto Mode is used for production running of the UltraAdvantage Servo Roll Feed. The feed is in the Manual mode
after powering it up, it can be put in Auto mode by pressing Cycle Start button and back to the Manual mode by
pressing Cycle Stop button.
The feed remembers a sequential step it gets stopped at, so when the Cycle Start button is pressed it resumes feeding
from that point.
During Manual mode, the feeder can be jogged infinitely in either direction. After the Cycle Start button is pressed,
the jog buttons are inactive, and the feeding of the strip follows the signals from the process machine.
5.2.1 PRESS APPLICATION
In the Press application the feed is controlled by a Feed cam signal and a Reset cam signal. The Gag outputs are
activated/deactivated at the beginning of every Feed signal, so the activation/deactivation of the tools happens during
the material feeding.
In applications with a cutting device where a backup move is required, the cutter bottom position sensor must be
installed and wired to the control.
If a value is assigned for the Back Length parameter, the feed will move the material back for the distance that equals
the Back Length if:
- the cutter bottom position sensor turns on between the end of the Feed Cam signal and the
beginning of the Reset Cam signal; and