3 “f1” key – PA Industries Edge Sequential Servo Roll Feed SRF-100/125/200/300/400/500/600 - Operation Manual User Manual
Page 10

ULTRA EDGE SEQUENTIAL 6
/05/2002
10
T # 1
A u t o M o d e
3 0 / C o n t . R u n
P r e s s a M o d e K e y
If saving is skipped, then the next screen allows deleting the tool being edited. Press “TOOLS” to open it. Press the
“ENTER” key, the warning message will be displayed, press “1” key to confirm deleting or any key to abort.
T # 1
D e l e t e T o o l <
T O O L S - n e x t B K S P - P r e v
D e l e t e T o o l # 1
P r e s s 1 t o c o n f i r m
A n o t h e r k e y t o a b o r t
The corresponding message on the next screen confirms the chosen command execution.
T o o l # 1 D e l e t e d
or
A b o r t e d !
Display will show FEED STATUS screen.
T # 1
A u t o M o d e
3 0 / C o n t . R u n
P r e s s a M o d e K e y
NOTE: To exit tool editing at any time, press the “OPER” key. Changes will not be saved.
3.3 “F1”
KEY
F1 allows manipulation of existing tool steps, performing such actions as adding steps, deleting steps, inserting steps,
and copying steps.
While being on any of the step screens press F1, the following screen opens.