B&K Precision 2640 - Manual - Manual (Page 54)

54
Save/Load
STEP 1
- Press the Shift key
STEP 2
- Press the Enter key
STEP 3
- To save the waveform or setup status, a name with at least 7 characters
is required.
- To select the first character. Use the Up/Down keys. And
press the Enter key
- If want to save the file name fewer than 10 characters, press the “END’
on stated inputted file name.
STEP 4
- To delete the character, press the Marker key
STEP 5
- When all 7 characters included blank are typed, press the Enter
key. Then, output message for SAVE OK is displayed.
“SAVE OK”
- If user does not type the all 7 characters included blank, the function of
save is not completed
STEP 6
- To cancel the Save, press the Marker key until the first character
is deleted. And additionally press the Marker key one time.
- Then the Save is canceled and the output message is displayed as
below.
“SAVE FAILED”
- The values to be saved are signal and system setting values. Buzzer,