B&K Precision 4052-4055 - Programming Manual - Manual (Page 7)

3
1.2. Table of Commands & Queries
Short Long Form Subsystem What Command/Query dose
*IDN *IDN SYSTEM Get identification from
device.
*OPC *OPC SYSTEM Get or set the OPC bit (0)
in the Event Status Register
(ESR).
CHDR COMM_HEADER Set the format of return data
(Long, short, off)
BSWV BASIC_WAVE SIGNAL Set or get basic wave
parameters. Turns on or off
channel signal.
ARWV ARBWAVE Data
SYSTEM Change arbitrary wave type.
BUZZ BUZZER SYSTEM Set or get buzzer State.
S_CFG SYSTEM_CONFIG SYSTEM Set or get power on
initializing parameter way
ROSC ROSCILLATOR SIGNAL Set or get clock source.
MOD MODULATION SIGNAL Set or get modulated wave
parameters.
OUTP OUTPUT SIGNAL Set or get output state.
CHCP CHANNEL_COPY SIGNAL Copy parameters from
channel one to channel two,
or from channel two to
channel one.
INVT INVERT SIGNAL Set or get output signal
phase state.
SCSV SCREEN_SAVE SYSTEM Set or get screen save State.
SWE SWEEP SIGNAL Set or get sweep wave.
SYNC SYNC SIGNAL Set or get in-phase signal.
BTWV BURSTWAVE SIGNAL Set or get burst wave
parameters.
MDWV MODULATEWAVE SIGNAL Set or get modulate wave
parameters.
STL STORE_LIST SIGNAL Get the list of store wave.
WVDT WAVE_DATA SIGNAL Get the wave data of store .
VKEY VIRTUALKEY SYSTEM Set the virtual key.