B&K Precision 4052-4055 - Programming Manual - Manual (Page 20)

16
EDGE When carrier wave is NOISE wave, you
can’t set it. When NCYC is selected and
TRSR is set to EXT, you can set it.
TIME When carrier wave is NOISE wave, you
can’t set it. When NCYC is selected, you
can set it.
MTRIG When TRSR’s parameter be chosen to
MAN, that it can be set.
CARR,WVTP Value of carrier wave type.
CARR,FRQ Value of frequency.
CARR,AMP Value of amplifier.
CARR,OFST Value of offset.
CARR,SYM Value of symmetry.
CARR,DUTY
Value of duty cycle.
Only Square can set this parameter.
CARR,PHSE Value of phase.
CARR,DLY
Value of carrier wave delay. This is
valid only when the carrier wave is
pulse.
CARR VAR
Value of carrier wave variance. This is
valid only when the carrier wave is
noise.
CARR MEAN
Value of carrier wave mean. This is
valid only when the carrier wave is
noise.
where:
:= {ON,OFF}
:= { Default unit is “S ”. 1us to 500s }
:= {0 to 360}
:= {GATE,NCYC}
:= {EXT,INT,MAN}
:= { Default unit is "S". 0s to 500s }
:= {NEG,POS}
:= {RISE,FALL,OFF}
:= { RISE,FALL}
:={ 1cycle to 50000 cycle}
:={SINE ,SQUARE, RAMP,PULSE,NOISE, ARB}
:= { Default unit is "HZ". Minimum value is 1xe-6 HZ,
maximal value depends on the version.}
:={Default unit is "V". Channel one
minimum value 0.004V, Maximal is 6V. Channel two minimum value
0.004V, Maximal is 20V. }