B&K Precision 4052-4055 - Programming Manual - Manual (Page 19)

15
EXAMPLE 4 Reads channel two modulate wave parameters that STATE is OFF.
C2:SWWV?
Return:
C2:SWWV STATE,OFF
1.8. Burst Wave Command
DESCRIPTION Set or get burst wave parameters.
COMMAND SYNTAX
:BursTWaVe
:={C1, C2}
:= {a parameter from the table below.}
Parameters
Value Description
STATE Enable or disable burst wave. Note if
you want to set or read burst wave
parameters you must first enable burst
mode.
PRD When carrier wave is NOISE wave, this
cannot be set. When GATE is selected,
you cannot set this. This can be set
only when trig source is IN (internal).
STPS When carrier wave is NOISE or PULSE
wave, you can’t set it.
GATE_NCYC When carrier wave is NOISE, you can’t
set it.
TRSR When carrier wave is NOISE wave, you
can’t set it. When NCYC was chosen
you can set it.
DLAY When carrier wave is NOISE wave, you
can’t set it. When NCYC was chosen
you can’t set it.
PLRT When GATE was chosen you can set it.
When carrier wave is NOISE, it is the
only parameter.
TRMD When carrier wave is NOISE wave, you
can’t set it. When NCYC was chosen
you can set it. When TRSR is set to
EXT, you can’t set is.