B&K Precision 4052-4055 - Programming Manual - Manual (Page 10)

6
1.4. Output Command
DESCRIPTION Enable or disable the output of the [Output] connector at the front panel
corresponding to the channel.
The query returns ON or OFF.
COMMAND SYNTAX : OUTPut
:={C1,C2}
:= {a parameter from the table below}
Parameters Value Description
ON --- Turn on channel
OFF --- Turn off channel
LOAD Value of load
where: := {50(default unit is ohm), HZ}
QUERY SYNTAX
: OUTPut?
RESPONSE FORMAT
:OUTPut
EXAMPLE 1
Turns on channel one.
C1:OUTP ON
EXAMPLE 2 Reads channel one output state.
C1:OUTP?
return:
C1:OUTP ON,LOAD,HZ
EXAMPLE 4 Set the load to 50Ω
C1:OUTP LOAD,50