B&K Precision 4052-4055 - Programming Manual - Manual (Page 17)

13
1.7. Sweep Wave Command
DESCRIPTION Set or get sweep wave parameters.
COMMAND SYNTAX
:SWeepWaVe
:={C1, C2}
:= {a parameter from the table below. }
Parameters
Value Description
STATE Turn on or off sweep
wave. Note if you want to
set or read sweep wave
parameters, you must
first enable sweep mode.
TIME Value of sweep time
STOP Value of stop frequency
START Value of start frequency
TRSR Trigger source
TRMD Value of trigger output. If
TRSR is EXT,
the
parameter is invalid.
SWMD Sweep way
DIR Sweep direction
EDGE Value of edge. Only TRSR
is EXT, the parameter is
valid.
MTRIG Make the device once
manual
trigger. The
parameter is valid only
when TRSR is set to MAN.
CARR,WVTP Value of carrier wave type.
CARR,FRQ Value of frequency.
CARR,AMP Value of amplifier.
CARR,OFST Value of offset.
CARR,SYM Value of symmetry.
CARR,DUTY
Value of duty cycle.
Only Square can set this
parameter.
CARR,PHSE Value of phase.
Note: If Carrier wave is Pulse or Noise, enabling sweep is not allowed.