B&K Precision 4052-4055 - Programming Manual - Manual (Page 13)

9
:={C1, C2}
:= {a parameter from the table below. }
Parameters
Value Describe
STATE
Enable or disable
modulation. Note: if you
want to set or read
modulating waveform
parameters modulation
must be enabled.
AM,SRC AM signal source.
AM,MDSP
AM modulation wave.
Only AM signal source is
set to INT.
AM,FRQ
AM frequency. Only AM
signal source is set to
INT.
AM,DEPTH
AM deep. Only AM signal
source is set to INT.
DSBAM,SRC DSBAM signal source
DSBAM,MDSP
DSBAM modulation
wave. Only AM signal
source is set to INT.
DSBAM,FRQ
DSBAM frequency. Only
AM signal source is set
to INT.
FM,SRC FM signal source
FM, MDSP
FM modulation wave.
Only FM signal source is
set to INT.
FM,FRQ
FM frequency. Only FM
signal source is set to
INT.
FM,DEVI
FM frequency offset.
Only FM signal source is
set to INT.
PM,SRC, PM signal source
PM,MDSP
PM modulation wave.
Only PM signal source is
set to INT.
PM,FRQ
PM frequency. Only PM
signal source is set to
INT.