B&K Precision 4052-4055 - Programming Manual - Manual (Page 11)

7
1.5. Basic Wave Command
DESCRIPTION Set or get basic wave parameters.
COMMAND SYNTAX
:BaSicWaVe
:={C1, C2}
:= {a parameter from the table below}
Parameters Value Description
WVTP Type of wave
FRQ
Value of frequency. This parameter
cannot be set for noise wave.
AMP
Value of amplifier. This parameter ca
nnot be set for noise wave.
OFST
Value of offset. This parameter cann
ot be set for noise wave.
SYM
Value of symmetry. This parameter is for
ramp wave only.
DUTY
Value of duty cycle.
Only Pulse and Duty can set this
parameter.
PHSE
Value of phase. This parameter cann
ot be set for noise wave.
VAR
Value of noise wave Variance. This
parameter can be set for noise wave
only.
MEAN
Value of noise wave mean. This
parameter can be set for noise wave
only.
DLY
Value of delay. This parameter can be set
for pulse wave only.
Note: if the command doesn’t set basic wave type, the parameter will set parameters to current
device wave type by default.
where:
:={SINE, SQUARE, RAMP, PULSE, NOISE, ARB ,DC}
:= { Default unit is "HZ". Minimum value is 1xe-6 HZ,
maximal value depends on the version.}
:= {Default unit is "V". Channel one minimum value 0.004V,