AUMA Electric multi-turn actuators SA 07.1 - 16.1_SAR 07.1 - 16.1 MATIC AM 01.1 - 02.1 - Manual (Page 26)

15. Test run
15.1 Checking the direction of rotation
.
If provided, place indicator disc on shaft.
The direction of rotation of the indicator disc (figure R-1) indicates the direc-
tion of rotation of the output drive.
.
If there is no indicator disc, the direction of rotation can also be observed on
the hollow shaft. For this purpose, remove screw plug (no. 27)
(figure R-2).
.
Move actuator manually to intermediate position or to sufficient distance from
end position.
.
Set selector switch to local control (I) (figure S).
.
Switch on the voltage supply.
.
Press push button CLOSE (figure T-1) and observe the direction
of rotation:
If the indicator disc turns counterclockwise, the direction of rotation
is correct.
If the direction of rotation is wrong, switch off immediately.
Afterwards, correct phase sequence in the connecting cable from the
wall bracket to the actuator and repeat test run.
26
Multi-turn actuators SA 07.1 – SA 30.1/ SAR 07.1 – SAR 30.1
with actuator controls AUMA MATIC AM 01.1 / AM 02.1
Operation instructions
Figure R-1: Indicator disc
CLOSED OPEN
Figure R-2: Opening the hollow shaft
27
S1/S2
Figure S: Selector switch LOCAL
Figure T-1: Push button CLOSE Figure T-2: Push button STOP