Atec Rohde-Schwarz-SMJ100A - Manual (Page 35)

Version 05.00, December 2007 R&S ® SMJ100A Vector Signal Generator 35
Specifications apply under the following conditions: 30 minutes warm-up time at ambient temperature, specified environmental
conditions met, calibration cycle adhered to, and all internal adjustments performed. Data designated "overrange" or "underrange" and
data without tolerance limits is not binding.
EMC specifications are tested with sufficiently shielded cables and accessories (e.g. mouse and keypad). To prevent degradation of
these specifications, it is the user's responsibility to use appropriate equipment.
In compliance with the 3GPP standard, chip rates are specified in Mcps (million chips per second), whereas bit rates and symbol rates
are specified in kbps (thousand bits per second) or ksps (thousand symbols per second). Mcps, kbps, and ksps are not SI units.
This document contains the specifications of the R&S ® SMJ100A, including RF characteristics, analog modulation, I/Q modulation, and
performance of the I/Q baseband generator. The functional specifications of the digital standards (R&S ® SMJ-K40 to -K61 options) and
the digital standards with external PC software (R&S ® SMJ-K5, -K6, -K8 options) are described in the Digital Standards data sheet
(PD 5213.9434.22). The digital standards with R&S ® WinIQSIM2™ (R&S ® SMJ-K240 to -K262 options) are described in the
R&S ® WinIQSIM2™ data sheet (PD 5213.7460.22), the digital standards with R&S ® WinIQSIM™ (R&S ® SMJ-K11 to -K20 options) in the
R&S ® WinIQSIM™ data sheet (PD 0758.0680.32).