Atec Anritsu-MG3710A - Manual (Page 35)

Data Sheet l MG3710A
35
Connector
External Reference Input
Connector: BNC-J (Rear panel), 50Ω (nom.)
Frequency: 5, 10, 13 MHz
Operating Range: ±1 ppm
Input Level: –15 dBm ≤ Level ≤ +20 dBm (AC coupled)
Reference Signal Output
Connector: BNC-J (Rear panel), 50Ω (nom.)
Frequency: 10 MHz
Output Level: ≥0 dBm (AC coupled)
Sweep Output
with MG3710A-017
Connector: BNC-J (Rear panel), <1Ω (Drive Capacity: 2 kΩ)
Output Level: 0 to 10 V (10 V Sweep Signal Function), 0 to 5 V (Sweep Status)
Local Oscillator (LO) Input
with MG3710A-017
Connector: SMA-J (Rear panel), 50Ω (nom.)
Frequency: 98 MHz to 6 GHz
Input Level: –10 dBm ≤ Level ≤ +1 dBm (AC coupled) (nom.)
Local Oscillator (LO) Output
with MG3710A-017
Connector: SMA-J (Rear panel), 50Ω (nom.)
Frequency: 98 MHz to 6 GHz
Output Level: ≤+1 dBm (AC coupled) (nom.) (Internal Lo output)
Baseband Reference Input
with MG3710A-017
Connector: BNC-J (Rear panel), 50Ω (nom.)
Frequency: 20 kHz to 50 MHz (External Baseband Reference Clock) ∗
560 MHz to 800 MHz (BB Ref Sync) ∗
Input Level: ≥0.2 Vp-p (AC coupled) (nom.)
Baseband Reference Output
with MG3710A-017
Connector: BNC-J (Rear panel), 50Ω (nom.)
Frequency: 560 MHz to 800 MHz ∗
Output Level: 0.8 Vp-p (AC coupled) (nom.)
Additional Analog Modulation Input
When MG3710A-050/080 is installed:
Connector: Rear panel, BNC-J
Input Impedance: 50Ω, 600Ω, or Hi-Z (100 kΩ/70 pF) (nom.)
Input Level: For set value, 2 Vp-p (nom.), Absolute maximum ratings: ±5 V
External Controller
Control from external controller (excluding power-on/off)
Ethernet (10/100/1000Base-T): RJ-45 (Rear panel)
GPIB: IEEE488 Bus connector (IEEE488.2, Rear panel)
Interface Function:SH1, AH1, T6, L4, SR1, RL1, PP0, DC1, DT0, C0, E2
USB (B): USB-B connector (USB2.0, Rear panel)
USB
Hard copies waveform to external device and saves main-frame basic parameters
USB-A connector (USB2.0, Front panel: 2 ports, Rear panel: 2 ports)
Monitor Output
Mini D-Sub connector (compatible with VGA, Rear panel)
AUX
50-pin (for DX10A-50S) (Rear panel)
Input/Output Level: TTL
with MG3710A-017/021: with AUX-BNC Conversion Cable
∗
: Supports firmware Version 2.00.00 and later.