Atec Anritsu-MG3710A - Manual (Page 33)

Data Sheet l MG3710A
33
Frequency Offset
± (200 MHz × 0.8 – waveform data bandwidth) ÷ 2 (max.) ∗ /
± (160 MHz × 0.8 – waveform data bandwidth) ÷ 2 (max.)
Sequences Function
Selecting combination file supports following functions:
• Pattern switching method (manual, auto)
• Pattern switching position (frame end, pattern end)
• External trigger signal switches pattern at manual pattern switching
• Sequence restart function
• Maximum element: 200
• Lowest number of point by pattern: 1000
Level Ratio Setting Range: Two signal level ratio <80 dB or Off
Level Setting Resolution: 0.01 dB
Frequency Offset
Frequency Setting Resolution: 1 Hz
Pattern Trigger
External trigger switches pattern when using waveform pattern for sequence
Input Connector
Connector: Either of BNC-J connector (Start Frame TRIG Input, Pattern TRIG1 Input) or AUX connector can be used
Input Level: TTL
Logic: Select Rise/Fall Polarity
Trigger Input
Function: Synchronizes with trigger signals and starts waveform pattern output; Switches start Trigger/Frame trigger
Start Trigger
Starts waveform output
Frame Trigger
Outputs signals at burst timing
Outputs data for burst length at frame trigger timing and waits for next frame trigger
Trigger Event
The following trigger events can be detected
No Retrigger, Buffered Trigger, Restart on Trigger
Input Connector
Function switching: Start trigger or frame trigger can be selected
Connector: Either of BNC-J connector (Start Frame TRIG Input, Pattern TRIG1 Input) or AUX connector can be used
Input Level: TTL
Logic: Select Rise/Fall Polarity
AWGN Generation Function
1st VSG: with MG3710A-049
2nd VSG: with MG3710A-079
C/N Ratio Absolute Value
≤40 dB
Bandwidth Limit Filter
Sets AWGN bandwidth limit as follows:
From 20% to 80% of waveform sampling rate
Sweep/List Function
Sweep Function
Function: Sets frequency and level sweep with 1000-point resolution
List Function
Function: Individually sets frequency and level with 500-point resolution
∗ : Supports firmware version 2.00.00 and later. Only when using MX370111A
WLAN IQproducer and MX370111A-002 802.11ac (160 MHz) option.