Atec Agilent-N5183A - Manual (Page 12)

12
Pulse modulation 1
(Option UNU)
On/Off ratio > 80 dB (typ) 2
Rise time < 50 ns (typ)
Fall time < 50 ns (typ)
Minimum width
ALC on ≥ 2 μs (typ)
ALC off ≥ 500 ns (typ)
Resolution 20 ns (nom)
Pulse repetition frequency
ALC on DC to 500 kHz
ALC off DC to 2 MHz
Level accuracy < 1 dB (typ)
(relative to CW, ALC on or off)
Video feedthrough < 350 mV (typ)
Pulse overshoot < 15% (nom)
Pulse compression 15 ns (typ)
Pulse delay
RF delay (video to RF output) 10 ns (nom)
Video delay (ext input to video) 30 ns (nom)
External input
Input impedance 50 ohm (nom)
Level +1 Vpeak = ON (nom)
Internal pulse generator
Modes Free-run, square, triggered, adjustable doublet,
trigger doublet, gated, and external pulse
Square wave rate 0.1 Hz to 10 MHz, 0.1 Hz resolution (nom)
Pulse period 500 ns to 42 seconds (nom)
Pulse width 500 ns to pulse period – 10 ns (nom)
Resolution 10 ns (nom)
Adjustable trigger delay – pulse period + 10 ns to pulse period to pulse
width –10 ns
Settable delay Free run –3.99 to 3.97 μs
Triggered 0 to 40 s
Resolution 10 ns (nom)
(delay, width, period)
Pulse
doublets
1st pulse delay 0 to 42 s – pulse width – 10 ns
(relative to sync out)
1st pulse width
500 ns to 42 s – delay – 10 ns
2nd pulse delay 0 to 42 s – (delay1 + width 2 ) – 10 ns
(relative to pulse 1)
2nd pulse width 20 ns to 42 s – (delay1 + delay 2 ) – 10 ns
1. Pulse specifications apply to frequencies > 500 MHz. Operable down to 10 MHz.
2. Applies to power levels > –5 dBm for Option 1E1.