Atec Agilent-E8257D - Manual (Page 8)

8
Output impedance 50 Ω (nom)
SWR (internally leveled)
250 kHz to 2 GHz
< 1.4:1 (typ)
> 2 GHz to 20 GHz < 1.6:1 (typ)
> 20 GHz to 40 GHz < 1.8:1 (typ)
> 40 GHz to 67 GHz < 2.0:1 (typ)
Leveling modes Internal leveling, external detector leveling,
millimeter source module, ALC off
External detector leveling
Range
–0.2 mV to –0.5 V (nom) (–36 dBm to
+4 dBm using Agilent 33330D/E detector)
Bandwidth Selectable 0.1 to 100 kHz (nom)
(Note: not intended for pulsed operation)
Maximum reverse power 1/2 Watt, 0 V
DC
Harmonics 1 (dBc at +10 dBm or maximum specified
output power, whichever is lower)
< 10 MHz –28 dBc (typical below 1 MHz)
10 MHz to 2 GHz –30 dBc 2,3
10 MHz to 2 GHz (with Option 1EH filters on) –55 dBc 4
> 2 GHz to 20 GHz –55 dBc
> 20 GHz to 67 GHz (Option 532, 540, 550 & 567) –50 dBc (typical)
Harmonics (measured)
1. Specifications are typical for harmonics beyond specified frequency range (beyond 50 GHz for Option 567).
2. Specification applies to units with serial numbers ending with 45130000 or greater. For units with lower serial numbers, the specification is –28 dBc.
3. Typical below 250 MHz if Option 1EH is installed and the filters are off.
4. In ramp sweep mode (Option 007), harmonics are –30 dBc below 250 MHz.
Spectral purity
Option 520 standard harmonic
performance (measured)
Frequency (MHz)
0 2000 4000 6000
-30
-40
-50
-60
-70
-80
Harmonics (dBc)
-3
-4
-5
-6
-7
-8
Harmonics (dBc)
armonic
ed)
Option 532/540 standard ha
performance (measured)
Frequency (MHz)
6000 8000 10000 0 5000 1000
-30
-40
-50
-60
-70
-80
Harmonics (dBc)
Option 567 standard harmonic performance
2nd harmonic (dBc)
Carrier frequency (GHz)
-30
-40
-50
-60
-70
-80
-90
-100
0 5 10 15 20 25 30 35
Standard
Carrier frequency (MHz)
Standard vs.Option 1EH harmonics (measu
2nd harmonic (dBc)
0
-10
-20
-30
-40
-50
-60
-70
-80
-90
0 500 1000 1500 2000
Option 1EH