Atec Agilent-N9038A - Manual (Page 14)

14
Preselector off, preamp on
Two –45 dBm tones at preamp input 1 10 to 500 MHz
500 MHz to 3.6 GHz
3.6 to 26.5 GHz
+4 dBm (nominal)
+5 dBm (nominal)
–15 dBm (nominal)
Preselector on, preamp off 10 to 30 MHz
30 MHz to 1 GHz
1 to 1.5 GHz
1.5 to 3.6 GHz
3.5 to 8.4 GHz
8.3 to 13.6 GHz
13.5 to 26.5 GHz
+12 dBm
+12.5 dBm
+12.5 dBm
+14.5 dBm
+15 dBm
+15 dBm
+10 dBm
+16 dBm
+15 dBm
+14 dBm
+16 dBm
+18 dBm
+18 dBm
+14 dBm
Preselector on, preamp on
Two –14 dBm tones at the input
with 22 dB input attenuation
10 to 30 MHz
30 MHz to 1 GHz
1 to 2 GHz
2 to 3.6 GHz
–9 dBm
–9 dBm
–4 dBm
–6 dBm
–5 dBm
–4 dBm
–2 dBm
–3 dBm
Two tones, each at –50 dBm at
the preamp 1
3.6 to 26.5 GHz −15 dBm (nominal)
Phase noise 2 Offset Specification Typical
Noise sidebands
(20 to 30 °C, CF = 1 GHz) 100 Hz
1 kHz
10 kHz
100 kHz
1 MHz
10 MHz
–84 dBc/Hz
–103 dBc/Hz
–115 dBc/Hz
–135 dBc/Hz
–88 dBc/Hz
–101 dBc/Hz (nominal)
–106 dBc/Hz
–117 dBc/Hz
–137 dBc/Hz
–148 dBc/Hz (nominal)
Figure 1. Nominal phase noise at different center frequencies
1. Preamp input power = input power-input attenuation ( – 9 dB for input 2).
2. For nominal values, refer to Figure 1.