Alpha Technologies Cordex CXCRF 48-300W - Manual (Page 17)

0300072-J0 RevA Page 13 of 46
2.6.4.6 LED
When the green LED is on, the LVD is active (closed).
When the LED is off, the LVD is not active (open).
2.6.5 Cordex Rectifier CXRF 48-300W
Figure 9 : Cordex Rectfier
2.6.5.1 LED R
ECTIFIER
S
TATUS
I
NDICATOR
The LED indicates the status of the rectifier:
• Green LED Normal conditions
• Orange LED Stand-by (remote on/off)
• Red LED Low output voltage
• Red blinking LED Failure (mains, temperature, output short circuit)
2.6.5.2 54V DC A
UXILIARY
O
UTPUT
This auxiliary 54V output allows the user to start with a basic bulk shelf without any controller or distribution unit.
Thanks to the modular architecture the user can upgrade the system when the application requires battery back-
up, system monitoring or redundancy. The output power is limited to 300W.
Auxiliary Output
GND + -
• Maximum conductor cross section: 2.0 mm² stranded (14AWG), maximum 8A current
• The auxiliary output connector on the front is a 3-pole Phoenix contact MC 1,5/ 3-GF-3,81.
The mating connector must be a 3.81mm (0.150”) pitch, 3 positions. It can be ordered from Alpha Technologies.