Alpha Technologies CFR 3000, CFR 3000RM - Manual (Page 74)

5 Maintenance 68
5.5 Configuring the Input/Output Voltage (Continued)
3 For the CFR 3000RM, remove the front panel by unscrewing the 6 screws and lifting the
panel away. Make sure you do not damage or disconnect the ribbon cable connecting the
display panel to the unit. Find the high voltage board labeled as “700–226–XX” (Figure
5.5).
4 On the high voltage board (Figure 5.6), reconfigure the wires and the jumpers as given in
Figure 5.7.
5 Reattach the front panel and cover. Turn the unit on (Section 3.1)
TIP: You may want to measure the output voltage to make sure this procedure has been
done correctly.
Voltage Reconfiguration Finished
Figure 5.5
High Voltage Board in CFR 3000RM