ABUS TVHD80010 Operating instructions - Manual (Page 73)

Important safety information
73
 To avoid the possibility of fires, the plug should al-
ways be disconnected from the network socket if the
device is not used for long periods. Disconnect the
device from the mains power supply before impend-
ing electrical storms, or use an uninterruptible power
supply.
Warning
Never open the device on your own! There is a
risk of electric shocks!
If it is necessary to open the device, consult
trained personnel or your local maintenance spe-
cialist.
 The installation or modification of a HDD should only
be made by trained personnel or your local mainte-
nance specialist.
Warning
The installation of additional equipment or modifi-
cation of the device invalidates your guarantee if
not carried out by trained personnel.
We recommend having the HDD installed by a
maintenance specialist.
Your guarantee is invalidated in the event of im-
proper installation of the HDD.
Overloading / overvoltage
 Avoid overloading of mains sockets, extension cables
and adapters as this can result in fires or electric
shocks.
 Use overvoltage protection to prevent damages
caused by overvoltage (e.g. electrical storms).
Cables
 Always hold cables by the connector, and do not pull
the cable itself.
 Never touch the mains cable with wet hands, as this
can lead to a short circuit or electric shock.
 Never position the device, furniture or other heavy
items on the cable. Ensure that the cable does not
become kinked, especially on the connector and
sockets.
 Never knot the cable, and do not tie it to other cables.
 All cables should be laid so that they cannot be
stepped on or cause an obstruction.
 A damaged mains cable can cause a fire or electric
shock. Check the mains cable from time to time.
 Never modify or manipulate the mains cable or plug.
 Do not use plug adapters or extension cables that do
not conform to the applicable safety standards, and do
not make alterations to power supply cables or mains
cables.
Installation location / operating environ-
ment
 Position the device on a firm, level surface and do not
place any heavy objects on the device.
 The device is not designed for operation in rooms
subject to high temperatures or moisture (e.g. bath-
rooms), or in excessively dusty rooms.
 Operating temperature and ambient humidity:
-10 °C to 55 °C, maximum 85% relative humidity. The
device may only be operated in moderate climate
conditions.
Ensure the following:
 Sufficient ventilation must be present at all times (do
not place the device in a storage rack, on thick car-
pets, on a bed or anywhere where the ventilation
slots are covered. Make sure that a gap of at least
10 cm is present on all sides).
 The device must not be exposed to direct heat
sources (e.g. heaters).
 The device must not be exposed to direct sunlight or
strong artificial light.
 The device must not be placed in close proximity to
magnetic fields (e.g. loudspeakers).
 Naked flames (e.g. candles) must not be placed on or
near the device.
 Contact with spraying or dripping water and aggres-
sive liquids must be avoided.
 The device must not be operated in close proximity to
water, and must not be submerged under any cir-
cumstances (do not place objects containing water on
or near the device, such as vases or drinks).
 Foreign objects must not penetrate the device.
 The device must not be exposed to strong variations
in temperature, as this can lead to condensation and
electrical short circuits.
 The device must not be exposed to excessive jolts or
vibrations.
Remote control
 Remove all batteries if the device will not be used for
a sustained period, as these can leak and damage
the device.