ABUS TVHD80010 Operating instructions - Manual (Page 101)

101
Zones: Schedule and notification
Note
You can assign the surveillance parameters indi-
vidually and control the notification type for tamper
monitoring, motion detection and video loss detec-
tion.
Handling
Trigger Channel
When “Reaction” is clicked, the TAB Trigger channel
appears (only with motion recognition):
Select one or more camera channels that should carry
out a reaction in the event of an alarm.
Confirm the settings by clicking Apply and leave the
menu with OK.
Armin Schedule
Select the TAB Arming Schedule.
Here you set the times when the reactions in the TAB
Reaction are triggered.
1. Select the day and enter the schedule.
Note
You can define up to 8 time periods (each from
00:00 to 00:00). The times in the individual peri-
ods must not overlap.
2. Select whether the settings should be applied to all
days of the week with using Copy.
3. Confirm the settings by clicking Apply and leave the
menu with OK.
Handling
Click on the TAB Handling.
Here you can configure the behavior of the recorder dur-
ing a detected event (for example: motion got detected)
by clicking the respective check box.
Parameter Notification
Full Screen Monitoring Message appears on moni-
tor
Audible Warning The device emits a repeat-
ing tone
Notify Surveillance Cen-
ter Sends an alarm signal to a
PC with the ABUS CMS
software. For this, the soft-
ware must be running and
the recorder must be in sur-
veillance mode.
Send E-Mail An e-mail is sent to a spe-
cific e-mail address (see
page 45)
Upload captured pictures
to FTP Saving the camera image on
a FTP server that has been
configured beforehand, see
p. 45 (only with motion rec-
ognition)
Trigger Alarm Output see page 47
 Confirm the settings by clicking Apply and leave the
menu with OK