ABUS FU8006 Secvest 2WAY Wireless Alarm Control Panel (UK, DK, IT) Operating instructions - Manual (Page 34)

34
Function Meaning
Set Date & Time Select this point to enter the date and time of the
wireless alarm system.
Date at alarm-center-reboot
01 / 06 / 2011 (S/W 5.06.45)
01 / 01 / 2012 (S/W 5.07.xx)
A3-X
Edit Outputs Select this point to change the times of the manual
output. The manual output is activated at the first
time entered and deactivated at the second.
Note: Outputs can be switched on and off using
a suitable remote control or by selecting the
“Outputs On/Off” user menu.
Telecommands Select this point to newly allocate the remote control
buttons. The fourth button of the remote control can
also be programmed here.
Note: If you do not have a remote control, press
“NO TELECOMMANDS”. A list of registered
remote controls and their users is shown on the
display. Select the remote control to be edited.
The corresponding keys can be selected using
the keys. Select the option on the display
you wish to use.
FU8100 wireless remote control
User Menu Æ System Config Æ Telecommands Æ
2 Way Instant Set Æ 2 Way Instant Set Y
2 Way Instant Set N
x “Y” (yes) is the default factory setting. The
alarm centre is activated immediately when
the FU8100 remote control is pressed.
x When “N” (no) is selected, the actions set
under the following positions are started
when the remote control is pressed:
Installer Menu
Æ Partitions Æ Partition 0x
Æ Ext Mode Æ Timed Set
Final Door Set
Instant Set
Silent Set
The exit delay time is started for “Timed
Set” or “Silent Set”, or the corresponding
action is started for
“Final Door Set” or “Instant Set”.
x Pay attention to the reception time of the
FU8100 remote control for feedback
(approx. 10 or 30 seconds).
After this period has elapsed, the FU8100
remote control cannot display any more
feedback.
Call Downloader Manually activates the selection of a phone number
for the remote control (if installed).
Summer/Winter
Time Selects between automatic and manual change
from summer to winter time.
Message Volume Selects the volume of the voice message.
Panel Sounder Vol The volume of operating, info and alarm tones
can be set in 5 steps here.
Installer access Defines whether the User code must be entered in
addition to the installer code to access the installer
menu.