NXG Technology NX-RM505 User Manual
Page 42
11. Setting Backlight
The Backlight can be toggled On and Off just by pushing the LIGHT
button on the top right side of the remote. It can also be set to go
off at a predetermined time, as shown below.
1
Go to the SETUP mode by pressing the MAIN and ENTER buttons
simultaneously for three seconds.
2
Press the LIGHT button next to the LCD screen.
3
Using the number pad buttons, enter the desired backlight time
(in seconds). It can go up to 99 seconds. Save the time by pressing
the button at the right side of the time you just assigned.
4
Exit from the SETUP mode by pressing the MAIN button.
Tip:
Note that the time you’ve entered in SETUP for the
Backlight to go off is extended each time you push a button.
So the light will go off at the predetermined interval AFTER
you have pushed the last button on the remote.
NX-RM505
42
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 42