NXG Technology NX-RM505 - Manual (Page 26)

6. Programming Macro Buttons
A ‘macro’ is a series of commands that you choose to be sent
out with the push of one button.
There are two types of macro functions you can program with
the NX-RM505 :
The M1, M2, M3, POWER and SYSTEM OFF buttons are designed
to send out up to twenty commands from each of the five hard
buttons. The ten device buttons can each send a macro of up to
20 commands when the device button is pressed for more than
1 second while on the MAIN page of the remote control.
Important: If you program the POWER or SYSTEM OFF Buttons
with a macro, they will no longer function as ON and OFF buttons
for your components. Just erase any macros you have programmed
on to these buttons if you want to restore the original ON and OFF
function. See the ‘Tips’ at the end of this section for help on pro-
gramming macros.
A. Programming Macro Functions To M1, M2, M3,
POWER and SYSTEM OFF Buttons
1 Go to the SETUP mode by pressing the MAIN and ENTER button
simultaneously for three seconds.
2 Press the MACRO button next to the LCD screen.
NX-RM505
26
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 26