NXG Technology NX-RM505 - Manual (Page 36)

8. Erasing Existing Programming
7 Press the MAIN button to exit to main Erase mode.
8 Press the MAIN button once again to exit the SETUP mode.
C. Erasing Macro Functions
1. Erase M1, M2, M3, POWER and SYSTEM OFF Buttons
1 Go to the SETUP mode by pressing both the MAIN and ENTER
buttons simultaneously for three seconds.
2 Press the ERASE button next to the LCD screen.
3 Press the MACRO button.
4 If you wish to erase all of the macro buttons in the NX-RM505 ,
press the ALL button and then press the SURE? button at the next
LCD screen.
5 If you wish to erase just one of the macros, press the KEY button at
step 4 and then one of the M1, M2, M3, POWER or SYSTEM OFF
buttons to erase the macro functions from that button.
6 Repeat from Step #5 to erase any other macro buttons you require.
7 Press the MAIN button to exit to main Erase mode. Press the MAIN
button once again to exit the SETUP mode.
NX-RM505
36
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 36